The Community for Technology Leaders
Proceedings IEEE Joint International Conference on Requirements Engineering (2002)
Essen, Germany
Sept. 9, 2002 to Sept. 13, 2002
ISSN: 1090-705X
ISBN: 0-7695-1465-0
pp: 214
T. Bertram , Gerhard-Mercator-Universit?
D. Kraft , Robert Bosch GmbH
A. Lapp , Robert Bosch GmbH
M. Bourhaleb , Gerhard-Mercator-Universit?
J. Schirmer , Robert Bosch GmbH
J. Petersen , Gerhard-Mercator-Universit?
P.Torre Flores , Robert Bosch GmbH
K. Knorr , Robert Bosch GmbH
Increasing demands concerning safety,economic impact, fuel consumption and comfort result in growing utilization of mechatronic components and networking of up to now widely independent systems in vehicles. The development of such a complex and networked system requires a coordinated, systematic development process. In this contribution a suitable process model will be presented. It supports the verification of a domain model considering functional requirements in an early stage of development. The process model takes two different types of modeling into account. Object oriented modeling is used to describe domain models and particularly supports aspects like re-use, exchangeability, scalability and distributed development. Data flow oriented modeling especially focuses on dynamic aspects and is employed to create a simulation model. Coupling points will be identified allowing an automated mapping of these two types of models.
T. Bertram, D. Kraft, A. Lapp, M. Bourhaleb, J. Schirmer, J. Petersen, P.Torre Flores, K. Knorr, "A Process Model for Distributed Development of Networked Mechatronic Components in Motor Vehicles", Proceedings IEEE Joint International Conference on Requirements Engineering, vol. 00, no. , pp. 214, 2002, doi:10.1109/ICRE.2002.1048530
48 ms
(Ver 3.3 (11022016))