The Community for Technology Leaders
Requirements Engineering, IEEE International Conference on (1998)
Colorado Springs, CO
Apr. 6, 1998 to Apr. 10, 1998
ISSN: 1097-0592
ISBN: 0-8186-8356-2
pp: 0024
Robyn R. Lutz , Iowa State University
Guy G. Helmer , Iowa State University
Michelle M. Moseman , Iowa State University
David E. Statezni , Rockwell Avionics and Communication
Stephen R. Tockey , Rockwell Avionics and Communication
ABSTRACT
Abstract: A safety analysis was performed on the software requirements for a family of flight instrumentation displays of commercial aircraft. First, an existing Safety Checklist was extended to apply to four-variable models and used to analyze the requirements models for representative members of the product family. The results were evaluated against an initial specification of the product family's required commonalities and variabilities. The Safety Checklist was found to be effective at analyzing the completeness of the product family requirements and at identifying additional variabilities and commonalities. Secondly, a forward and backward search for hazards was performed on representative members of the product family. Additional safety requirements for enhanced fault tolerance were derived from these searches. The safety analysis techniques used here appear to have applicability for enhancing the completeness and robustness of a product family's safety-related software requirements.
INDEX TERMS
Safety, requirements analysis, product family, avionics.
CITATION
Robyn R. Lutz, Guy G. Helmer, Michelle M. Moseman, David E. Statezni, Stephen R. Tockey, "Safety Analysis of Requirements for a Product Family", Requirements Engineering, IEEE International Conference on, vol. 00, no. , pp. 0024, 1998, doi:10.1109/ICRE.1998.667805
50 ms
(Ver 3.3 (11022016))