This Article 
   
 Share 
   
 Bibliographic References 
   
 Add to: 
 
Digg
Furl
Spurl
Blink
Simpy
Google
Del.icio.us
Y!MyWeb
 
 Search 
   
May/June 2005 (vol. 22 no. 3)
pp. 193
Rajesh Gupta, Editor in Chief, IEEE Design & Test
The design-manufacturing interface (DMI) is one of the most critical junctions in the chip industry. For years, designers have debated the interplay of technologies on both sides of this interface. In this issue, D&T examines another current topic that deeply touches this interface: design for manufacturability (DFM).
Index Terms:
design-manufacturing interface, DMI
Citation:
Rajesh Gupta, "The other face of design for manufacturability," IEEE Design & Test of Computers, vol. 22, no. 3, pp. 193, May-June 2005, doi:10.1109/MDT.2005.59
Usage of this product signifies your acceptance of the Terms of Use.